Can-Am Defender HD9 Atlas Pro 1.5" Forward Offset A-Arms

If you're running your Can-Am Defender hard on the trail, your stock A-arms are working overtime. These replacement A-arms swap out the weak factory setup with something that'll actually hold up to mud, rocks, and whatever else you throw at it. Built with tubing that's half again thicker than what came from the factory, they're designed to take a beating and keep going. The best part? They let you fit up to 31-inch tires without needing a lift kit, and they give you real adjustability when it comes to dialing in your camber angle.

This is a complete A-arm kit from SuperATV. You get the upper control arms with 7/8-inch heim joints and lower monoball joints, ready to bolt on. The heim joints come pre-set to factory specs, so you can install them straight away or adjust them later to match your setup.

The tubing is chromoly construction—1.5-inch diameter, which is substantially thicker than stock parts. The upper heim joints are the real deal: solid 7/8-inch units that give you room to fine-tune your camber without guessing. Down below, the monoball joints are lined with PTFE material, which doesn't wear out quickly and handles years of flexing and movement.

That forward offset isn't just a number—it means you've got the clearance to run bigger rubber without cutting into your wheel wells. You also gain a bit of extra ground clearance with the custom bend design. Stack that with the heavier-duty tubing, and you've got arms that resist damage from flying rocks and rough terrain.

• Can-Am Defender HD 9: 2022+
• Can-Am Defender HD 9 DPS: 2022+
• Can-Am Defender HD 9 XT: 2022+
• Can-Am Defender MAX HD 9: 2022+
• Can-Am Defender MAX HD 9 DPS: 2022+
• Can-Am Defender MAX HD 9 XT: 2022+