Polaris RZR XP 1000 High Clearance 1.5" Forward Offset A-Arms (Chromoly)

When you're pushing your Polaris RZR XP 1000 through rough terrain, stock A-arms limit what you can do. They sit low, they're narrow, and they'll hold you back. These high-clearance A-arms give you the extra room you need to tackle steeper hills, navigate bigger obstacles, and open up trails you couldn't reach before. With a smart dual-bend design and a 1.5-inch forward offset built in, you get real ground clearance plus the ability to fit up to 32-inch tires—no lift kit required.

SuperATV built these arms from 1.25-inch diameter chromoly tubing with a 3.5mm wall thickness—that's 25% thicker than what comes stock. The steel alloy itself is one of the strongest materials used in suspension work. Each arm comes with threaded ball joints pre-installed, plus UHMW bushings that handle years of abuse without needing lubrication. The whole setup gets a UV-resistant powder coat to handle sun exposure and look clean doing it.

The threaded ball joints here aren't your typical off-the-shelf parts. They're forged from 4340 steel with an M38 thread design that screws directly into the A-arm housing. No taper, no weak points—just a solid stud that locks down with thread locker and a snap ring. Installation is straightforward, and the strength speaks for itself.

Your new arms come set to stock specs, so bolt them on and go if you want. But if you add cab weight or a small lift later, the adjustable pivot blocks let you dial in your camber to cut down tire wear and keep everything balanced.

These come with a lifetime warranty, so you can push hard knowing you're covered.

• Polaris RZR XP 1000: 2014-2023
• Polaris RZR XP 4 1000: 2014-2023