Yamaha Viking 3-in-1 Windshield

Your Yamaha Viking takes you everywhere—sun, rain, dust, cold mornings, hot afternoons. Keeping the weather out of your face shouldn't mean choosing just one type of protection. This 3-in-1 windshield lets you run full coverage one minute, flip it down for airflow the next, or remove the top half and leave it behind when you want minimal obstruction. Switch between all three setups without killing the engine, so you adapt to conditions on the fly.

Three Ways to Ride

Got wind and flying debris in your face? Flip the windshield up and lock it down with magnets for a full protective seal. Heat building up? Drop it to the half position and let air flow through. Expecting clean, dry conditions? Pull off the top section entirely and ride with just the lower half—or leave both pieces at camp. The quick-release clamps and patent-pending latches make swapping between modes dead simple.

Built to Take a Beating

The polycarbonate construction is seriously tough. It's 250 times stronger than glass and 25 times tougher than acrylic, so rocks, branches, and trail debris won't leave you with cracks or breaks. The 1/4-inch thick material handles constant abuse without failing. SuperATV backs this with an XR Optic Hard Coating on both sides that resists scratches and abrasion while blocking UV damage—no yellowing, fading, or clouding over time.

Install and Go

You won't spend half the day bolting this on. The clamps, latches, and rare-earth magnets fit tight without rattle or movement, and everything locks down in minutes. No custom drilling, no complications—just get it mounted and ride.

What You Get

• Full windshield panel
• Flip-down mid section
• Half windshield option
• Quick-release clamps and latches
• Magnetic attachment hardware

Fitment

• Yamaha Viking : 2014+
• Yamaha Viking EPS : 2014+
• Yamaha Viking EPS Ranch Edition : 2018+
• Yamaha Viking EPS SE : 2015+
• Yamaha Viking VI : 2015-2017
• Yamaha Viking VI EPS : 2015+
• Yamaha Viking VI EPS Ranch Edition : 2016+
• Yamaha Viking VI EPS SE : 2015-2016

Note: Does not fit with OEM roof 1XP-K8314-00-00. Works with most hard and soft tops.

Made at our Madison, Indiana facility.